 |
|
|
|
|
Product Details:
Payment & Shipping Terms:
|
| Product: | 35 KV(33kV) Cross-arm Line Post Insulator | To Be Used In: | 35kV Electric Power Lines And Substations |
|---|---|---|---|
| Insulator Color: | Grey Or Red | Common Package: | Paper Tubes Cartons Or Wooden Boxes |
| Standards: | IEC 61952/ANSI | Insulator Types: | FS-35/10-MJ-620 To FS-35/10-MJ-630 |
| Material: | Polymer Or Composite | Conducted Tests: | All Type Tested And Design Tested |
| High Light: | composite post insulator,polymer post insulator |
||
Small Volume Cross - Arm Solid Core Post Insulators 35kV for Electrical Powerline
Specifications:
Dimensions and Characteristics of 35kV(33kV) Cross-arm Line Post Insulators
| Figure. No | Model | Rated Voltage | Specified bending Mechanical Load | Section Length |
Insulating length |
Minimum Creepage | Full-Wave Impulse Withstand Voltage (Peak) |
1 Min Wet Power Frequency Withstand Voltage |
Weight (for Reference) |
|
kV |
kN |
H mm |
h mm |
L mm |
≥ kV |
≥ kV |
kg |
||
| 2.4-1 | FS-35/10-MJ-630 | 35 | 10 | 630±5 | 468 | 1600 | 300 | 150 | 7.5 |
| 2.4-2 | FS-35/10-MJ-620 | 35 | 10 | 620±5 | 468 | 1600 | 300 | 150 | 7.5 |
Description:
1, 35kV Cross-arm Insulator are widely used in power transmission lines and substations.
2, Dead end fittings are up to the requirements from the clients, usually we use different flanges for post insulators with forged steel or cast steel. The dimensions and coupling size can be exactly according to the specification requirements from the utilities.
3, The silicon rubber color of the insulators are also up to the requirements from the clients and all the silicon rubber materials past 5000 hours aging test silicon content test and hydrophobicity test.
4, ECR core rods are used in all the insulators, so we can guarantee a very good mechanical strength and anti-acid pollution performance for the insulators.
5, All our insulators were type tested and design tested in accordance with IEC61952, maximum RIV is 100µV when tested at 1MHz and10% over nominal line ground voltage for indicated system voltage.
6, All the Cross-arm Insulators with the voltage lower than 110kV are not supposed to use corona ring.
All the Cross-arm Insulators with the voltage equal to or higher than 110kV but lower than 220kV are supposed to use one corona ring at the line end.
All the Cross-arm Insulators with the voltage equal to or higher than 220kV are supposed to use two corona rings at both sides.
Applications:
1, Usually used in 35kV substations
2, Usually used in 35kV Electric Power Lines
Features/ advantages :
1. Good performance of hydrophobility
2. Anti-pollution
3. High mechanical strength
4. Small volume
5. Light weight
6. Can replace the porcelain ones because of the good anti pollution, convenient installation and free from maintainance performance.
Our services
1. We offer the best solution and products to fulfill the buyers' requirements.
2. We can arrange technicians to install the equipments and train your staff on site.
3. Anytime, we provide considerate technical consultation.
4. Prompt reply for your inquiry and feedback.
5, OEM service is also available with us.
